7/22/2023 0 Comments Gitup git2 amazon![]() Now, this might be different on other platforms and operating systems, but I doubt it. The github webhook page reports this response: Headers In my tests, GIT2 works great as a webcam on Windows 10. I tried manually executing the code build as well but got this error: COMMAND_EXECUTION_ERROR: Error while executing command: python3 - << "EOF" from boto3 import client import os s3 = client('s3') kms = client('kms') enckey = s3.get_object(Bucket=os.getenv('KeyBucket'), Key=os.getenv('KeyObject')).read() privkey = kms.decrypt(CiphertextBlob=enckey) with open('enc_key.pem', 'w') as f: print(code("utf-8"), file=f) EOF. I am not sure what to configure for allowed IP's, so I tested fully open. This quickstart I tried to use looked like it could do it, but it doesn't result in success for me, even though github reports success in pushing via the webhook for my repository. I decided I did not really want to mess with it any longer, because things seemed kind of flaky and unrealiable - but that was obviously just my experience - I gave up after how easy the gopro worked.I'd like to try and automate an S3 bucket replication of a Github repo (for the sole reason that Cloudformation modules must reference templates in S3). I did not end up liking my setup though, atleast not once I got my gopro, so I returned the Git2. They have the free designs cataloged and the websites software does all the 3D printing calculations automatically (even lets you know if the part will not print correctly) and you do not have to get into all the nitty gritty of 3D printing stuff. ![]() The parts turned out really well and I got um relatively cheap because I ordered several parts at the same time all with the same base specs (color, fill-ratio, etc.) so I was only charge one $10 setup fee (the parts themselves cost anywhere from $1.50 - $6 depending on what I was buying and how many I was ordering. The 3D printed parts are available and i purchased from "", their 3D Co-OP-like printing service. The stock solo gimbal HDMI connector works on this camera after you cut away a bit of the plastic underneath the connector - careful not to slice into the rubber covering the HDMI cable as I did, nearly slicing the wire, making my backup gimbal useless. Duo Pro Pack With Main Camera Only, GitUp G3 Duo 170 Pro Pack With Main Camera : : Elettronica. The gimbal functions as smooth as it did with a GoPro. GitUp Git2 Sony IMX206 Sensor version Firmware. The fact that the Git2P weighs 23grams less than the GoPro Hero 4 Black helps. I was worried the gimbal would have a problem with the new camera sitting a quarter of an inch forward but it was not a problem. A small amount of trimming of plastic corner under the HDMI cable solved this problem. The HDMI cable was a couple of mm to short to plug into the camera. Velcro is simple and secure plus it makes it easy to change cameras. I use a Velcro strap to hold the camera in place. Then I carefully cut off the rounded tab, on the left side, that was used to hold a GoPro, but was now in the way. Since the GIT2P has to sit in front of the connector, I made a quarter inch thick pad for the camera to rest against (see photo), using the black dense foam that came with the gimbal. I did not want to remove it, because I still want to be able to use it with a GoPro. The first problem I had to deal with was the connector that plugs into the back of a GoPro. Use of this camera required some modifications to the SOLO gimbal, but I made sure that I can still use a GoPro if I want.
0 Comments
Leave a Reply. |